GPIB card has an device /instrument
Hello, I would like to configure my NI-GPIB card as a device/instrument rather than as the controller. So that i can be an instrument on another controller's network. It is not clear to me how to...
View ArticleWhere is NI MAX and Visa?
I wanted to install NI Max on a new computer. I ended up with the Hardware Configuration Utility. When It can't find my devices it will give a pop up message that says to launch NI MAX. This link does...
View ArticleClik here to view.
What does this error mean for Property Node (arg 1) in VISA Configure Serial...
Hello.I am working on a project to drive an optical switch using LabVIEW.However, when I checked the block diagram, the Property Node (arg 1) error of VISA Configure Serial Port (Instr).vi kept...
View ArticleRun Assembly code in LabView.
Hello, We have a motherboard from Advantech model PCE-7132. This board has an integrated watchdog controller (WD) and is controlled by the NCT 6776 chipset.In the operating manual we have assembly...
View ArticleDisabled resource manager
Resman is disabled at NI MAX. My PC is running with Windows 7. Two VXI system is detected.
View ArticleControlling Agilent 8510C Network Analyzer and GPIB-USB with Matlab
I want to control Agilent 8510C NW analyzer using Matlab. I am using GPIB-USB controller. I am able to send commands to the NW analyzer and can change the start and stop frequencies and Marker...
View ArticleI need help setting up GPIB with Hitachi F-4500 spectro fluorometer
Hello I recently purchased a used Hitachi F-4500 spectro fluorometer and installed the necessary GPIB drivers on my windows 11 PC and made all changes in order to communicate with the device.But the...
View ArticleError in setting up VISA resource for Keithley 2460
I have a system with two Keithley 2460's that I want to control with LabVIEW. One is set up and works fine (done long time ago - the person who did it is gone), but I am having trouble communicating...
View Articlepcie 8430/2 device manager does not see driver
in Windows 10, the card shows up in Other Device \PCI communication with a yellow question mark.I tried to install NI-serial driver 21.0 , but it did not see it.. The details show correct VEN 1093 DEV...
View ArticleNI-488.2 Drivers Prior to 17.6 for win 98
Hello everyone, I need to use a USB NI GPIB interface (GBIP-USB-HS) on Windows 98 and therefore I need NI-488.2 drivers prior to 17.6 which is not available on NI webpage. Download page only has...
View ArticleClik here to view.
Send Hex string over Modbus to SMC Actuator
Hi,I am trying to send a hex string command to multiple holding registers via Modbus to an SMC traverse. I know I need to convert this string to a byte array, but I cant use the "string to byte array"...
View ArticleError 85 on LeCroy 44Xi Scope
I am trying to communicate to LeCroy scope 44Xi using Ethernet port TCP/IP. I am getting below error 85. Anyone had face this issue and got the resolution?I am using LV 2022 Q3 and already installed...
View ArticleClik here to view.
Disconnect All Channels VI with Virtual MUX
I'm getting error -29038 when I use "niSE Disconnect All.vi" to clear all channels of my MUX Virtual Expansion 128 channel mux with single channel exclusion. Each NI mux card is 64 channels, each...
View ArticleUsing a NAT9914, with TI transceiver ICs, any solution to TI's EOL of...
I'm currently using the NAT9914 in conjunction with Texas Instruments' SN75161BDW and SN75160BDW transceiver ICs. Recently, Texas Instruments issued a Product Change Notification (PCN) announcing the...
View ArticleDisplaying FFT of SR780 Network Analyzer in LabVIEW
Hi, I am trying to control the SR780 network analyzer with LabVIEW to give a signal from its internal sinusoidal source and get the corresponding FFT into the LabVIEW vi. I connected the device...
View ArticleNI-VISA 17.5
Hello guys, I am trying to download NI-VISA 17.5, to use with my GPIB interface, but for some reason the page has an error and I am not getting.I am from Brazil. Does anyone can help me?
View ArticleDriver 488.2 download page not found
Hello,I'm trying to download the driver 488.2, 20.0 version with the download botton at the following link:https://www.ni.com/it-it/support/downloads/drivers/download.ni-488-2.html#345631When I click...
View Articlelooking for Red hat VISA driver, Ver 5.4 , for red hat 5.11
looking for Red hat VISA driver, Ver 5.4 , for red hat 5.11
View ArticleProblem in communicating GPIB USB-HS with Solartron SI1260 + Novocontrol BDC
Hello. I've been trying to control a NOVOCONTROL "Dielectric Broadband Converter" (BDC) and 1260 SOLARTRON "Impedance Analyzer" with a GPIB-USB-HS using NOVOCONTROl WinDETA v.3.7 software on Win ME.On...
View ArticleNI-488.2 .NET Programmer Reference Guide
Where can I find .NET programmer documentation for the NI-488.2 library? Everything I have been able to find is for the Win32 DLL.
View Article