Dear All,
I use the "Visa Configure Serial Port.vi" from "Instrument I/O->Serial" pallet in my application, to get access to the serial com port on my sbRio-9636.
When running the application the error out from the "Visa Configure Serial Port.vi" states the code -1073807202.
Result by LabView help: "-1073807202: VISA or a code library required by VISA could not be located or loaded. This is usually due to a required driver not being installed on the system."
So I did check out the installed drivers by M&A Explorer and found no NI-VISA drivers installed. I installed the NI-VISA 5.1 from drivers list (Fig1), but still get the same error. Are there further drivers which have to be installed corresponding to COM-Port access by VISA? Currently I only have drivers installed at shown in Fig2.
Thanks in Advance for your help.
Regards,
ar-numa