NI 488 PCI settings

I am having issues with moving my NI488 PCI to a win 10 comp. I downloaded and installed the 2.7.3.49152 drivers. It looks good in DEVMAN but in Measurement and automation explorere it cannot find a connected instrument. I have mirrored the settings from the old computer in the interface properties but no joy. they are 

GPIB0

Bus Timing 500ns

Cable length for high speed disabled

Primary Address 7

Secondary Address None

Terminate read on EOS Yes

Set EOI with EOS on write No

8 bit EOS compare No

Send EOI at end of write Yes

EOS byte 10

System Controller Yes

I/O Timeout 10 sec

Parallel Poll duration default

Enable Auto Serial Poll No

Enable CIC Protocol Yes

Assert REN when SC Yes
what am I missing?