Hi,
I need some help regarding the Eurotherm 3500 series communication, I am using 3500 series for controlling a fan and a feedback from a mass-flow sensor, with labview on a computer, how should I set it up?
1-is my fan (Modbus RTU, EIA 485) a slave 1? massflow sensor (Modbus RTU, EIA 485) slave 2?
2-how is the wiring for them?Just link the two slaves together to Eurotherm 3500 HA to HF? and JA to JF is for the LabVIEW computer?
or use one 3 units of 3500 series 1 for master and 2 for slaves?how is the wiring then?
It would be better if someone can put on a wiring schematic here and the setup as I am completely new to this as a mechanical student.
Thanks for your kindest help.