Windows 10 is not recognizing my NI 9211 in my NI USB-9162 carrier.
I am just getting back into this stuff, I have been away from this for the last decade or so I am on a relearning curve, so please assume my product knowledge is a bit dated.
I installed the latest NI-daqmx, version 19.5 in my windows 10 computer today, and have started to try getting my NI measurement hardware running again. I was able to get a driver created and signed for my USB instrument rack, a NI USB-9162.
It now shows in device manager,under NI-VISA Devices, but it is named " Device model name" - this seems wrong.
In max, it's listed as USB0::0x3923::0x719A::NI-VISA-60002::RAW - this seems wrong too.
I can launch a visa test panel (see capture2.jpg attached) - this is also not very informative.
When I load my NI 9211 C Series Temperature Input Module into the USB-9162 slot, I do not see it in MAX, or device manager. It does not launch or install.
Any ideas on how to get the hardware to launch / be recognized?
attached snips are device manager,max,visa test panel respectively
Thanks,
Jim