Quantcast
Channel: Instrument Control (GPIB, Serial, VISA, IVI) topics
Viewing all articles
Browse latest Browse all 5673

Wiring to Non-standard RS-485 Device

$
0
0

I am designing an RS-485-based system for reading differential pressure from a pressure transducer. The attached diagram from the datasheet shows the pinout of the device, and the manufacturer confirmed the pinout this way:

 

Pin 1: Power +

Pin 2: Output +

Pin 3: Common (Also serial port common)

Pin 4: Power –

Pin 5: Tx

Pin 6: Rx

 

Obviously the pin out includes neither differential Tx and Rx pins nor Data (A)+ or Data (B)- pin designations, which seem to be the standard ways of wiring RS-485 devices together. (I have received the command list from the manufacturer, and it includes a command for setting the address of the slave device, which tells me that this is indeed an RS-422/RS-485 device.)

 

I'm planning to connect to the device with an NI 9871. I've read the 9871 Getting Started Guide (http://www.ni.com/pdf/manuals/372277g.pdf) and this KB (https://knowledge.ni.com/KnowledgeArticleDetails?id=kA00Z000000P7mNSAS&l=en-US), and I'm pretty sure that my best bet is to try wiring the device up in 2-wire mode. However, I'm not sure which pairs of pins to short together on the NI 9871 side to make it work. Do I need to short TX+ & RX+ together and TX- & RX- together or short TX- and RX- together and wire that to the common of the device? Has anyone seen this topology before?

 


Viewing all articles
Browse latest Browse all 5673

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>