Hopefully this is the correct forum.
I have a USB-8452 that I am using to talk to some equipment with over a SPI bus. The problem is that when increasing the clock rate, that doesn't speed up the communication as a whole.
Scope captures....
Clock at Lower frequency (KHZ)
It looks ok but has pauses between the bursts of 8. (It's writing from an array of 8-bit unsigned as the out of the box VI requires)
Clock at Higher frequency (MHZ)
The clock speed increases but the breaks between the communication remain the same.... this seems totally wrong to me.
Can anyone offer insight on how to correct this so it's a continuous clocking of data?
Thanks,
Kellen