I have a simple SPDT relay on the 34903A card, hooked into a 34972A DAQ Unit.
The COM is a 5V supply from an external source,and I have the NO pin hooked up to an input externally as well.
When testing this relay on the front, it works fine.
However, I am unable to actuate it remotely. I send the following cmd:
"ROUT:CLOS (@301)"I dont get any errors back and I get a return message from the cmd. However, the relay doesnt actually switch.
As soon as I make a connection to the 34972A, the front panel no longer gives me control for open/closing the channel also.
If I use the same command on an unused channel(@302), it works even remotely.
What is going on here?