Switch PXIe - 2527 skipping channel

Good evening,

I am trying to make a thermocouple measurements with PXIe-2527 and DMM 4080 based on the accompanying example by NI.

My switch config - 

Scan list - "ch0:ch10->com0;"

My switch config

Than what I do is basically - 

1. Set 10 thermocouple  channels

2. start scan 

3. measure with DMM

4. Repeat for all required thermocouple values

for some reason I find that channels are skipped with the following pattern:

Notice the second row in the fist column the third row in the second channel...

Any one had similar issue?

Am i doing something wrong with my scan config?

Thanks,

Barukh