Hello,
I have the Keysight 67xx IVI driver installed (AgN67xx.dll). I can run the simulation mode no problem through the NI VI "N67xxOutputExample_1.vi". The simulation grabs the:
InstrumentFWRevision as "Sim1.3.5.0"
measured Voltage of "6.74473E-6".
As well as some other items, but the ones listed are hard-coded into the AgN67xx.dll.
Now I want to use the nisDCpwr Simulation Driver Software Module within NIMAX.
NI MAX Relevant My System>>Software:
IVI Compliance Package 4.5
NI-VISA 16.0
My System>>IVI Drivers>>Logical Names is setup with DcPwr1, pointing to Driver session is N6711a
My System>>IVI Drivers>>Driver Session is N6711a, Simulate With is pointing to nisDCPwr.
My System>>IVI Drivers>>Advanced>>Simulation Driver Session is nisDCPwr, Simulation Driver Software Module is pointing to nisDCPwr
Regardless of what I switch the "Simulate With" in the N6711a Driver Session, the simulation comes back with the same AgN67xx.dll responses of:
InstrumentFWRevision as "Sim1.3.5.0" every time, expected should be "A0.01.01" from Initial settings in Simulation Driver Session
measured Voltage of "6.74473E-6" every time, expected should be random number between 0-10volts
I have searched as much as I think I can possibly cover, unless I missed something. Is there a setting I am missing? Any help into were to look next would be greatly appreciated.
Best Regards,
Andrew