I am using a SpinCore PulseBlaster LabVIEW Extensions
It gives me the message below,
Error 0 occurred at an unidentified location
Possible reason(s):
LabVIEW: Error connecting to GPIB driver or device. The NI-488.2 driver may not be installed.
=========================
NI-488: Error connecting to driver or device. The NI-488.2 driver may not be installed.
=========================
VISA: (Hex 0x0) Operation completed successfully.
In the past, maybe before some updating, it works quite well. I uninstalled and reinstalled it again both the NI 488.2.15.0 and SpinCore PulseBlaster driver, the problem is still there, it still gives the same error messages. I have checked the SpinCore PulseBlaster Card, PCI interface installed, the card install has no problem, use their original C code can generate pulse sequences.
Can anyone help me with this issue? Thanks a lot!
Dewen Duan