I am having issues getting my PXIe-5160 4-ch scope to work with the IVIScope drivers. I am taking a measurement over 400us with a min record length of 10,000. When I prepare a reading on channel 0, this works fine. But then when I go to do the same thing on channel 1, it gives me the attached error message. I do want to be able to capture data on both channels, or even all four maybe. I do not see anywhere to set the sample rate. This seems to be a read only attribute that the device should be figuring out itself. I do not see the problem as at 400us long, 10,000 samples, that's only 2.5e7 rate needed which is way slower than the max of 1.25e9 it can do.
↧