Hi everyone,
I'm trying to interface with an old Newport MM3000 motion controller using Labview VIs, but I am not able to communicate with the device. I can program and interface with the motion controller just fine using the NI 488.2 communicator, but none of the Labview VIs, including those included with the downloaded Labview drivers for the MM3000, allow me to write to or read from the device. The GPIB address for the VI inputs is the same one that is listed in MAX (GPIB1::1::INSTR), and I am using only the included MM3000 drivers, but even the simplest of commands, consisting only of the aforementioned drivers and a few inputs, does nothing. I'm new to Labview, so my problem may be very simple, but I would really appreciate some suggestions.
Thanks!