Hi All,
I am trying to setup my network analyzer to take impedance measurement (R + XJ smith chart) of my UUT , at different fixed frequencies. I need to set my NA to :
Network Analyzer settings
- Format = Smith / R+jX
- Measure = “S11”
- Scale = “Auto Scale“,.
“Scale/Div = 1.0000UFS”,
“Electrical delay = 0.0000s”
- Average = “Average Factor = 2“
“Averaging = ON”
“SMO Aperture = 1.5000%”
“Smoothing = OFF”.
“IF Bandwidth = 300 Hz”.
- Center = 30 MHz
- Span = 0
- Sweep Setup= “Sweep Time = Auto”
“Sweep Delay = 0.0000s ”
“Points = 10”
“Sweep Type = Lin Freq” - Trigger = “Continuous = ON”
“Trigger Source = Internal”
Marker = “Marker 1 = ON”
“Ref marker Mode = OFF”
I tried modifying the example program but it doesn't work. please help me if you are familiar with this network analyzer. thanks.