Hello I upgraded a computer system from Windows XP to Windows 7 and from LabVIEW 7.1 to LabVIEW 2014. With my VI I'm comunicating with a Harmonic Drive SC-610 servo controller (RS232 connection on my serial port COM3) which controlls a Harmonic drive motion drive. Also there is a Faulhaber Motion drive connected on another serial port (COM4).
In the old system both ports where usable as GPIB but not so in my new system. There I get the error message Error connecting with the GPIB device or driver when I want to start my VI. NI VISA and 488.2 are installed. Also MintMT, MintWorkBench and Faulhaber Motion Drive are installed.
Is there anything I need to consider when moving from LabVIEW 7.1 to LabVIEW 2014 to fix this problem? How can I install the GPIB?
Best Regards