I've been trying for the last week or so to get Labview (7.1) to work with an HP-Agilent-Keysite 82350A GPIB under Windows XP.
I've read through a lot of the Forum posts and gleaned some valuable information but still no joy. My understanding is that I need to install the HP driver and then load the Tulip passport in MAX to allow Labview to recognize the card. I have done these things to no avail. I have also swapped-out the 82350A card, suspecting that it was defective, and rebooted more times than I can remember.
The 82350A card is connected to two instruments, a 3014A Tek scope and a 34970A HP measurement MUX. Both instruments advise that they have active GPIB addresses during power-up. I've tried using one or both at different times and swapped out the cables as well.
The system/hardware path in XP shows the card installed and enabled, the driver tab shows the HP driver is installed and recognized.
When I try to look at the card and instruments in Labview, I get the message that Tulip cannot be loaded.
I have attached a .doc file that shows screenshots of MAX and XP/system/hardware in hopes someone may see something I've missed. The images are a little small but the resolution is good so a zoom makes the screenshots quite legible.
I would be grateful for any assistance.