I use Labview 6.1 vi to control a Tektronic oscilloscope and a BNC universal pulse generator via GPIB-USP connection. The vi worked very well with the system windows XP. The system was changed to Windows 7. Then one error message (Trigger signal is not recognized. Check the connection between 'Trigger out' and 'Aux in') comes whenever I start to run vi. The connection between 'Trigger out' and 'Aux in' works under mannual mode, so it is really ok.
Could the compatibility between Labview 6.1 and windows 7 be the reason? If yes, are there tricks to use Labview 6.1 on windows 7? Thanks.