Hi,
First of all I need to say that I just beginning with the instrument control using Labview. For this reason, it's possible that the problem that i have would be easy to resolve. However, I have been looking for any solution for the forum, but unfortunately I can't fint anything.
Then the situation is the following: I'm trying to connect a power analyzer (Yokogawa WT1800) with the PC through GPIB. To achieve this objective I use the Agilent 82357B USB/GPIB Interface. The connection is done properly because I can see and comunicate with it through the NI MAX explorer.
In order to achieve the instrument control using Labview, I have downloaded and installed the Yokogawa WT1800 driver (ykt1800 Instrument Driver) using the NI Instrument Driver Finder tool. The problem that I have is that when I execute the provided examples I find the following error:
Error -1073807330 occurred at Property Node (arg1) in Yokogawa WT1800 Series.lvlib: Initialize.vi -> Yokogawa WT1800 Series Measure Continuos Normal.vi
Possible reason(s):
VISA: (Hex 0xBFFF001E) The specified state of the attribute is not valid, or is not supported as defined by the resource,
I tried to change the input arguments of the Visa open vi because I think that is there where is the problem but I can't achieve any solution. In the following image is attached the block diagram of the initialize.vi:
Any help is appreciated.
Thank you.