I have been having a very frustrating problem happening with my GPIB-ENET/100. I can connect to the device and communicate with instruments but I need to change the IP address of the unit. The ethernet configuration utility cannot find the device, even though I am in the same sub domain and can ping the device with no issue. (yes I am using a crossover cable)
Also, MAX will not let me delete the device. The option to delete is greyed out. This has happened with more than one unit now.
I tried a factory reset on one unit, but now I cannot connect to it via a crossover cable, as it defaults to DHCP mode.
Please give me some better hints at a solution than the manual.