Hey All,
I am currently using a GW Instek PSM-2010 programmable DC power supply and I have been trying to progarmmably increase the voltage output while performing temperature ramps on my sample. At the present time, I am only able to reach a voltage of about 1.2 with a max current of 20 amps. Theoretically I should be able to operate at 8 V when using a max current of 20A. Does anyone know what driver VI will allow me to reach this capability? Or does the problem lay within the temperature ramp programming that was established by my predecesor? When I try to change values in some of the driver VI's that are used in my programming, they seem to reset to a default value. Any insight would be much appreciated. Thanks! - A_babs