I have a LabView GPIB interface running on an old XP PC system. It runs a Tektronix waveform generator and an Agilent Multimeter. Unfortunately both instruments predate usb buses. The system also has a multiIO card (which I would replace with a usb 16 bit A-D). I would like to upgrade the GPIB system to run on the Community Edition of LabView in Windows 10 or Windows 11. I know GPIB is a dinosaur and it appears it is no longer supported by NI? I have considerable money invested in the equipment and being retired money is dear. Is it possible to run a GPIB bus on the newer LabView versions or am I just asking for trouble? Any sage advice will e most appreciated.