Just acquired an HP 54602A scope and it looks like the screen keys are locked, from a previous user I would guess with
the :SYSTEM:LOCK command.
I need to gain access to the scope via its GP-IP/HP-IP to set the SYSTEM:LOCK OFF command.
Last time I used LabV was in the 80's so let's say I know nothing...
I was hoping there was a pre-canned piece of software that was written that would just allow configuration commands
to be sent to the scope via (GP-IP/HP-IP) / RS-232 interface...
Thus allowing a bunch of software, that will not be used, to be installed.
I have a typical WIN-10 install running...
Thanks in advance.
Chuck