Hello, I start to work on this device "CVC 3000" for control and data collection. It is in fact a pressure regulator.
I made a small program, I managed to display the value of pressure in continuous mode with VISA, but my problem since I read the manual of command interface, I can not control my instrument for a given value of pressure, I launch the set point but it goes down and until below this value, it does not make the regulation therefore.
I don't know if I have mistyped the commands or if there is a problem somewhere
So my question is: how can I use these command instructions with VISA, to be able to control my instrument and enter a pressure set point and what exactly meets the need?
I put you attached screenshots and the program thank you all!
gghhgh
