I am developing one “Start” button to control Optris CSmicro Infrared Thermometer, instead of the designated “Run” Button. So, I apply an event structure in a while loop to control Optris CSmicro Infrared ThermometerCSmicro LT15 (OPTCSMALT02SF0505K). In the Visa Configure Serial Port, the stop bit is tuned to 1. When I run the program, the following error message is obtained in the attached file, “Error – 1073807330 occurred at property node in Visa Configure Serial Port.” As the stop bit is tuned to 10, then the waveform chart shows the temperature. Is it correct to tune the stop bit equal to 10 in the Visa Configure Serial Port for this Infrared Thermometer?
However, when I press the “IR Theremometer” button, the waveform chart always get a burst initially in the attached figure. (It seems that the initial burst is related with the start button.)How can I prevent the initial burst?
Thank you for your suggestion in advance.