Hi all
After finishing scope acquisition I need to disable = disconnect scope channels. Idealy all of them.
I tried to setup attribute "IVISCOPE_ATTR_CHANNEL_ENABLED" to FALSE but this will disconnect channel only during next acquisition .
I tried IVI Scope Reset - but this will not disconnect channels.
I tried IVI Scope Self Test - but this will not disconnect channels.
I know that NI Scope Soft Panel could disable channels.
How I could do it from TestStand + IVI Steps
My configuration:
TestStand 2019
NI IVI
NI Scope drivers
NI PXIe-5105 (8 channels)
Thank you
Peter