Hello,
I have a CAN-FD setup with XNET and a CAN device from a company called PEAK. My simulator transmits many CAN messages on the bus, two of which are CAN-FD 500Kb +2MB BRS, and ISO mode. There is also an automotive ECU transmitting two CAN-FD messages and some others on the same BUS.
The Peak tool sees all of the messages, including the 4 CAN-FD messages(2 from the simulator and 2 from the ECU). The XNET card, and or USB(8502) module only see the two CAN-FD modules from the ECU, and not the 2 from the simulator.
I'm sure it's not a termination or cabling issue, any other ideas?
Regards,
Terry Moss