Greetings all,
I am a beginner to LabView and I am using it to interface with the SR830 Lock-In amplifier. I am using the SR830 drivers by Stanford Research to create a program whereby I can record the values obtained from Channel 1 (for amplitude) and Channel 2 (for phase). However, the data acquisition is very erratic and sometimes it works and sometimes it doesn't. The error messages that I get are not the same as well and varies from time to time.
I tried following the example given by Stanford Research (attached) and replicating it to work for two channels. My trial program (SR830_Trial) has also been attached. Could somebody help to see why my program would not run? Thanks a million.