Hello,
On my test benches I have several Serial instruments. I would like to use Ethernet-to-Serial converter modules to control them through Ethernet.
I just found some modules which are Ethernet/Serial protocol translators.
The one I'm testing is the WIZ750SR (see more here : http://wizwiki.net/wiki/doku.php/products:wiz750sr:start)
While the module is well recognized on the network, I can't create it under NI MAX. First, it is not auto-detected, and even if I manually set the IP address, it doesn't work
I get the error "(Hex 0xBFFF0011) Insufficient location information or the device or resource is not present in the system."
I tried to make a loopback test by shorting RX to TX on the Serial side of the module, but it still not working...
Have you some suggestions?
Your help is very appreciated!
JB