Driving an Invensense MPU-6000-EVB with a NI USB-8452

Good evening,

I am attempting to use an NI-8452 to communicate with an Invensense MPU-6000-EVB using an SPI protocol.  It's an accelerometer/gyrometer/magnetometer sensor.  I'm a bit rusty with LV, and so I'm trying to modify existing code (specifically, the examples found in General SPI Read.vi and General SPI Write.vi as the first steps in my development.  I was wondering if any in the community had experience in this area, and could offer advice.

For reference, I can offer:

MPU-6000 Evaluation Board User Guide (which is the physical board to which I am connecting the 8452)

MPU-6000 Product Specification (which details the chip information)

MPU-6000 Register Map (which defines where the information is accessed)

Thanks!