Hello,
I am trying to automate some measurements using LabVIEW which require me to use the Rohde & Schwarz NRV Power Meter. I am trying to make a simple measurement and display on the Read buffer indicator as shown in the figure attached.
As you can see, the data read out of the device into the read buffer indicator on the front panel is not a numeral although the power meter displays the proper reading on its display. Since, it is an RF power meter I was expecting to see something like "0" as in 0 dBm. Also, the front panel sends out a warning(code:1073676294) indicating that there might be more data than the specified number of bytes being read. How can I get VISA to get me the appropriate value? Any comment in this regard is highly appreciated.
Thank You,
Vivek