Hello,
I require to measure the rotational speed and acceleration of a rotor that has 3 hall sensors on it.
I have uniquely identified the 6 Hall Sensor states with an iteration count from 0 - 10921 which is being read in LabVIEW during runtime.
There are 24 pulses which occur for every 360° mechanical rotation.
I wasn't sure if there would be any issues with maintaining speed measurements due to reiteration which is occurring during runtime.
I am currently attempting to keep the count value using shift registers, however I haven't succeeded to implement that yet, maybe a fundamental mistake on my part
?
Is it possible to measure speed with only the reiterative values - if so could someone point me in the right direction with an example of how this can be achieved?
Many Thanks.