connection between Optidiver (E) and labVIEW using 'TCP open connect', savy device through Ethernet cable

Hello LabVIEW users! 

I am new to LabVIEW program and trying control the variable refrigerant flow compressor speed through LabVIEW program. Using the following LabVIEW functions and hardware..

1. TCP Open connection: IP address has been defined in the TCP open connection.
2. Speedy: (driveweb.com) : This speedy device is connected with network card using Ethernet cable.
3. OPTIDRIVE E : This device controls the ‘Variable Refrigerant Flow” compressor speed(manually and based upon LabVIEW written program). This device is connected to network card through speedy by using Ethernet cable.

Hardware configuration:

OPTIDRIVE E ( IP 20 & IP66 (NEMA 4X)  AC variable speed drive ( 0.37 – 11 kW) ( 110-480 V)

Questions:

     1. Has anyone tried this before, if yes can you share the instructions.. ?

2.   what’s the simplest way to know whether the network card receiving signal from NI LabVIEW and communicating with OPRIDRIVE E ?

Any help will be appreciated !

Thanks!