Hi everyone.
My question to you is: How can I get back to my old firmware on my pci-gpib controller after updating it?
I just purchased a vintage, late 90's, colorgetter drum scanner that runs off the pci-gpib on a mac. It did not come with a mac so I picked one up for $60. It was loaded with os10.4. With the drivers installed it would crash on boot. The forum said to upgrade firmware. I did. Boot problem solved. However, after the fact, I learned the scanner software only ran on os9.0 and earlier. After loading os9 the software cannot see the scanner. I need to get back to the old firmware that used drivers NI-488-2 ver. 7.6.6.
Any help would be greatly appreciated.