Hi,
I'd like to build a labview program that I can both send and receive signal with for about 30 minutes in water pipe by using some transducers and transreceivers.
I am using ni6281 daq and I'm planning to use the sampling rate up to 200khz. I have built one program that it can both send and recieve signals but it has some problems as follows:
1-)Sending and receiving are not synchronized.
2-) I can't save the data for more than 1 min due to lack of memory problem.
3-)I want to have a signal which can show timing instead of number of samples.
If you could help me to build a bit more engineered program or another similar example that I can play with it would be appreciated.
Thanks