IndraControl S67 - NI Tools - Rexroth Open Core Engineering driver

I am trying to understand the application scope of Rexroth Open Core Engineering LabVIEW Add-on available on the NI Tools Network,

the http://sine.ni.com/np/app/main/p/bot/no/ap/lvtn/lang/en/pg/1/sn/n25:software,n21:28,n20:16641/sb/default/q/Rexroth/

I have an S67 unit, Fieldbus Coupler utilizing Ethernet/IP - the S67-ET-BK-DI8-M8

It is unclear from the documentation if full control and configuration of this device is supported in the LabVIEW MLPI4 toolkit from Rexroth.

Anyone have any experience?  I don't have the hardware to test unfortunately.  I have contacted Tammon (he has posted about the Open Core Engineering package before on the forum.

Just hoping to hear from anyone with experience integrating with these units in LabVIEW.

Thanks.