Hey all,
My supervisor wants to switch out our cRIO setup for a cDAQ setup to allow for better control via the computer. I work in a lab where we do HVAC testing in psychrometric chambers are used to test electrically-driven mechanical heating and cooling equipment. These chambers are controlled using LabView software and updates to the code and control verification needs to be performed to actually get testing tolerances to standard.
My labview experince is on the low side of the specturm, but i understand that cRIOs are set up to use a base written FPGS code in them where as the cDAQ is set up to just run from labview? The Labview code was set up by a third party, and has become littered with bugs as we've set up different tests / had multiple lab techs messing with it.
Has anyone done this kind of switchover? I'm currious if that anyone has had issue with essentially having to rewrite their program or if it is a painless switch?
Thanks for the read!
SamB.
(Also I apologize in advance I am unable to post the code)