Quantcast
Channel: Instrument Control (GPIB, Serial, VISA, IVI) topics
Viewing all articles
Browse latest Browse all 5680

AIT MIL-STD-1553 PXI not communicating with LabVIEW

$
0
0

I have an AIT MIL-STD-1553 PXI card, and I am trying to control it using LabVIEW. The card shows up in MAX, and a Test Panel is able to communicate with it, as shown in the attached images. Further, if I open a VISA session with the instrument, it seems to be okay. (I have only tried doing a VISA Open and VISA Close, resulting in no error. Since I don't know any other VISA commands to this instrument, and since it does not seem to speak SCPI, I have been limited to simply opening and closing the VISA session.) However, when I try to do a simple Initialize using the AIT LabVIEW vis, I get an error code -1, stating that there is "No Hardware Found". This simple vi is shown in the other attachment. (I did not attach a snippet, because without the AIT DLL it would be useless anyway.) I have also tried different "network path in", and "board index in" values, without success. Any time I change the network path in to anything but "local", I get an error code -5, stating that "Remote network connection not supported by this hardware".

 

I have verified that the latest AIT firmware is loaded on the card. I'm running the AIT LabVIEW vilib components, and LabVIEW 2015.

 

Any help would be greatly appreciated.

Thanks.

Dan


Viewing all articles
Browse latest Browse all 5680

Trending Articles