I am doing a project in which I am receiving data bby Xbee at remote end.I have set the baud rate of sending and receiving side,115200. I need to send 3000 bytes every time. With the baud rate mentioned, the data must be received in less than a second. I have used LabVIEW for displaying the data waveforms.Now the problem is I am receiving data in 2 seconds in Xctu.but in LabVIEW if I receive the same data and plot it,the waveforms get disturbed.But if I increase the sending time,say 7 seconds,the waveforms are good.Now the problem is with LabVIEW speed to update the previously received data with new data so that I could plot the waveforms correctly.That's why I e want to give complete access of com port to LabVIEW. Please help me.
↧