I am trying to use two different GPIB-USB connecters on one computer-(1 Keithley KUSB and 1 NI GPIB-USB-HS) to communicate in LABVIEW.
To use NI's GPIB to USB, you need to install NI's 488.2 and need to make sure no other GPIB communication software is installed.
To use Keithley GPIB to USB, you need to uninstall NI's 488.2 software and use the Keithley Specific Driver, GPIB-488 ver 9.2. (This has been covered by a few posts on the forum)
My problem is that I can get both devices to work individually with their respective softwares but not togather.
I am wondering, has anyone found a work around for a similar type of problem?
Are two different 488 software protocols not allowed on the same computer?