Hi,

I would like to know if the NI USB GPIB HS+ is supported under Red Hat 7.0 (kernel 3.10.0-123.8.1.el7.x86_64).

I would like to use it for normal GPIB control and I understand that the analyzer capability is only available under Windows.

I successfully installed the NI 488.2 15.1 package. From a terminal, when I run "lsusb", I can see the NI USB GPIB HS+ (as well from the dmesg output).

But when I run the /usr/local/natinst/ni4882/bin/gpibtsw  tool to check the installed GPIB controllers, nothing is reported.

According to the documentation published on the NI web page, my USB GPIB HS+ is supported. But is there a problem with

Red Hat 7.0 although it is listed as supported in the system requirements? Or is there something special that needs to be done with the USB GPIB HS+ (which works fine as an analyzer on my Windows 7 laptop)?

Thanks in advance for your support.

NI-488.2 15.1 for Linux

The following devices are supported for use with this download:

• AT-GPIB/TNT (PnP)
• GPIB-ENET/100
• GPIB-ENET/1000
• GPIB-USB-B
• GPIB-USB-HS
• GPIB-USB-HS+
• NI ExpressCard-GPIB
• NI PCIe-GPIB

-------------------
System Requirements
-------------------
This release of NI-488.2 for Linux software supports the following
distributions:

CentOS 7
openSUSE 13.1
openSUSE 13.2
Red Hat Enterprise Linux 6
Red Hat Enterprise Linux 7
Scientific Linux 6

Pierre