HI there,
I am using an Agilent 33521B waveform generator and I'm contolling it via GPIB.
I would like to run a sequence in LabView that triggers two frequency sweeps one after the other, each with different sweep parameters.
For instance the first sweep would have a start frequency of 100Hz and stop frequency of 1KHz over 500ms seconds and then immediately after i would need to trigger a second sweep with start frequency of 1KHZ to 20KHz over 1 second.
I have attempted to do this using a flat sequence and waiting until the first sweep has finished and then change the sweep parameters before triggering the second. However when i do this, there is a delay between the sweeps that seems to not be consistent between runs which isn't good, plus the waveforms do not look too healthy when viewed on an oscilloscope
I have attached my code below. I am also using the "Agilent 3352X Series" drivers for this, which i have also attached.
Any help on getting the sweeps to commence immediately after one another would be very much apprectiated
Regards
Rhys