Hİ guys, I am not sure about writing under the correct forum section but this section seems to me the most relevant one. Anyway, my problem is to communicate an USB daq device of Measurement Computing, model USB 4301, to labview 2014 SP1. I installed all required drivers and programs, however, I can see the device neither on NI MAX nor Labview 2014 SP1. The device is recognize only by the program called "Instacall" which is shipped with the device drivers setup. All labview drivers are seen under the user libraries, there is no problem on that. It is said that the Instacall write an configuration file, CB.cfg, however, I cannot locate it even that I search on whole C partition of the HDD. How can I solve this issue?
This are quoted from the help file of ULx NI Labview drivers:
"To configure your hardware, complete the following steps:
- Close NI LabVIEW if it is running.
- Connect the MCC hardware that you want to use in NI LabVIEW.
- Open InstaCal and configure the hardware. InstaCal assigns a board number to each device it detects on the system. The board number assigned to the device in InstaCal is the number used to recognize the device in NI LabVIEW.
- Close InstaCal.
Note: NI LabVIEW reads the CB.CFG configuration file created by InstaCal. If you need to change any device settings make sure that NI LabVIEW is closed before you open InstaCal.
"
The program & driver that I installed from here (MCC DAQ CD, ULx for NI Labview)
By the way the software I am using is Win 10 Pro 64-bit.