Dear smarter people than me, I have been pulling my hair out trying to get my brand new ENET-232/4 units running under the lastest and greatest LabVIEW envirenment (2014).
After finding that none of the instruction matched what I was seeing in MAX etc, I discovered the following line in the NI-Serial 14.0 driver release notes;
Release Notes
Removed ENET support
NI-Serial 14.0 removes support for all NI Serial ENET Interfaces (ENET-232/2, ENET-232/4, ENET-485/2, and ENET-485/4).
So my question is if NI-Serial no longer supports or configures the ENET-232/4, then what does? At the moment I just have 5 rather exspensive boxes sitting on the shelf unable to be configured.
Smart brains please help 
Dave