Hello,
i'm a german student, using LabVIEW now, but at one point got stuck.
So, i'm using a PCI 6024e Card and a BNC 2120. LabVIEW Version, not sure, quite old, around 6.0 or 6.1 I guess.
Furthermore i got a pH-Sensor with an BNC connector-plug.
When i measure the voltage over that sensor, I get a relative high voltage and the voltage is permanent falling after some minutes.
Got someone an idea why the voltage isn't constant? Any idea what to check/improve?
I would also appreciate any advices of what hardware I could buy to get this project started.
Thanks
Regardful
G-rooon