9870 Problem With Remote Panel Server

I am using a CRIO-9014 with two C-modules installed (NI-9870 and NI-9402). The 1 khz speed of the Scan mode is not fast enough for what I need to do with the 9402, so I am using the Hybrid Mode where the 9402 is under  the FPGA target and the 9870 in under the Chassis. My code runs fine using Scan mode drivers for the the 9870 and the FPGA mode for the 9402...however, it runs fine only when running the code while in the Labview development environment. If I deploy the code to run at startup on the RIO and display data through the Remote Panel Sever, I loose the 9870. In other words, serial port I/O stops. The 9402 still works as does my remote panel . What gives? Any ideas out there?

Thanks,

Steve